top of page
Writer's pictureAbbey

DIY Pottery Barn Pumpkin Pillows

Updated: Oct 23, 2022


It doesn't matter where you go, you are bound to come across these adorably cute sherpa pumpkin pillows in stores or online. After looking I couldn't believe how expensive it was to buy a bunch of these pumpkins. I decided to get creative and save some money and make my own. I came across this tutorial from @forthehome that saved me $530!!!


I filmed a DIY YouTube video to show you step-by-step how to make the pillows yourself but listed below are the material and instructions to make this super easy DIY project yourself. If you make them comment below and let me know how it turned out.


Hope you enjoy it!


Materials:

❤️Fabric for your pumpkin (3 different colors for small, medium, and large)

🧡Burlap

💛Poly-fil

🤎Unicorn Horns (I found them at Joann's)

❤️Krazy craft glue

🧡Scissors

💛Jute string

🤎Upholstery thread (you’ll need strong thread for this project)

❤️Tapestry needle


*** I bought all my supplies at Joann Fabric with a 30% off coupon.***


Instructions:

🎃Cut your fabric into a rectangle. Here are the measurements I used for my sizes!


Large pumpkin: L: 44.5” x W: 21.5”

Medium pumpkin: L: 35” x W: 15”

Small pumpkin: L: 22” x W: 11”


🎃Take your tapestry needle and thread and sew a running stitch along both of the long edges of the rectangle. Make sure to leave a tail of thread (a couple of inches) at both ends of the fabric.


🎃Fold your fabric in half, with the fluffy side facing in, and stitch along the short edge.


🎃Once you finish pull the two tail threads on one edge and tie them shut. This is the bottom of your pumpkin!


🎃Next, stuff your pillow and then tie it shut. You can tuck in the loose thread inside of the pillow.


🎃Take your jute string and guide it under the pillow. Bring it to the top, cross the string over and wrap it back around the bottom of the pillow. Continue this step, altering from the top and bottom of the pillow. This is how you create those cute sections in the pumpkin! It’s kind of like wrapping a present. Continue this step until you’re happy with the sections. Make sure to tie the string tight when you finish!


🎃For the stem, cut the unicorn horn to the size you’d like and glue it to the pumpkin.


🎃Glue jute string around it to cover the styrofoam.


🎃To finish, glue a little burlap square on top of the stem and trim around it once the glue is dry! And voila!




Recent Posts

See All

Comments


bottom of page